Supply of vacuum-insulated cryogenic tanks for storing liquid nitrogen LIN (N₂) with volumes of 10, 20, 30 and 50 m³. Complete with ambient vaporizers, pressure regulators, shut-off and safety valves and pipelines. Turnkey installation and commissioning of nitrogen supply systems.
Model: CT-N2-10
Stationary vacuum-insulated cryogenic tank for storing liquid nitrogen (LIN, N₂), geometric volume 10 m³. Supplied with valves, pressure control, vaporizers and a pressure-reducing unit; turnkey installation available.
Price on request
Made to order
Model: CT-N2-20
Stationary vacuum-insulated cryogenic tank for storing liquid nitrogen (LIN, N₂), geometric volume 20 m³. Supplied with valves, pressure control, vaporizers and a pressure-reducing unit; turnkey installation available.
Price on request
Made to order
Model: CT-N2-30
Stationary vacuum-insulated cryogenic tank for storing liquid nitrogen (LIN, N₂), geometric volume 30 m³. Supplied with valves, pressure control, vaporizers and a pressure-reducing unit; turnkey installation available.
Price on request
Made to order
Model: CT-N2-50
Stationary vacuum-insulated cryogenic tank for storing liquid nitrogen (LIN, N₂), geometric volume 50 m³. Supplied with valves, pressure control, vaporizers and a pressure-reducing unit; turnkey installation available.
Price on request
Made to order
A stationary liquid nitrogen tank replaces cylinder deliveries with a continuous, low-cost gas supply. We supply vacuum-insulated LIN tanks from 10 to 50 m³ together with ambient vaporizers and pressure regulators, sized for your actual consumption profile.
Liquid nitrogen boils at −196 °C, so insulation quality directly defines daily losses. Vacuum-insulated tanks with an ambient vaporizer give a stable gas supply without cylinder handling and with far lower cost per cubic metre.
Tanks for liquid nitrogen (LIN, N₂) are available in 10, 20, 30, 50 m³. Smaller volumes suit workshops and pilot lines; 30 m³ and above are typical for continuous industrial consumption and for sites that receive full tanker deliveries.
| Volume | Liquid, t | Gas, thousand m³ | Typical use |
|---|---|---|---|
| 10 m³ | 7.4 | 6.3 | pilot lines, small workshops and laboratories |
| 20 m³ | 14.9 | 12.5 | medium plants with steady consumption |
| 30 m³ | 22.3 | 18.8 | continuous consumption, takes a full road tanker |
| 50 m³ | 37.2 | 31.3 | large plants, several consumers on one site |
We select the equipment, deliver it, install it on prepared foundations, complete the process piping and commission the gas supply system on a turnkey basis.
We fix the price in a quotation after sizing the tank to your consumption — so you do not pay for volume you will not use.
Gas quality and standards
Boiling point, liquid density, gas yield per kilogram and per litre, critical temperature and hazards — the figures engineers look up most often, in one place.
Gas quality and standards
4.6, 5.0, «special purity grade 1» — three ways of writing the same idea. What the numbers mean, which grade each process needs, and what to check in the certificate.
Equipment selection
Nitrogen is colder, dry ice holds more cold per kilogram. A side-by-side table, the tasks each one is right for, and the safety difference people forget.
Installation and operation
Liquid nitrogen cannot be stored — only slowed down. Loss rates by vessel type, why a sealed container is dangerous, and what a room with liquid nitrogen needs.
The vacuum-insulated vessel comes with its piping: shut-off and safety valves and pressure and level instruments. Vaporizers and pressure-reducing units are selected for your consumption. Installation, pipelines to the consumer and commissioning are offered as a turnkey package.
Start from the monthly consumption, the delivery frequency of your gas supplier and the required reserve. As a rule of thumb, the tank should hold 1.5–2 deliveries. Send us your consumption figures and we will size the tank and vaporizer for free.
Yes. We provide the basic data for the foundation design, and your contractor builds it for the specific site. The foundation is sized for the weight of the filled tank; the site also needs tanker access and a fenced area with the safety distances required by the standards.
The tank arrives with a full document package and all certificates from the European manufacturer. A specialised company then issues the pressure vessel passport, and this set is submitted to the State Labour Service (Derzhpratsi).
No. We take responsibility for the system we have selected and supplied ourselves: tank, vaporizer, pipelines and start-up. If you have your own installer, we can sell just the tank or the vaporizer.
Send your monthly gas consumption and site conditions — an engineer will work out the tank volume, vaporizer capacity and scope of supply.
